Pine Cone Crafting

As the school year approaches, the day of our wedding looms closer. We are ALMOST at the 100 day mark! I took one of my last free weekends, and spent the morning with one of my bridesmaids crafting! I found this general concept on Pinterest but made it my own.

What you’ll need:

Pine cones (I used cinnamon scented craft/decor ones)

1/4 inch ribbon

3/4 inch ribbon

1 inch ribbon


Hot glue gun

Jingle bells of varying sizes (optional)

*please excuse the newspaper I used to protect the table!* 🙂

I am going to hang these on the ends of pews, backs of chairs, and a few other places. I created loops with a 6-8 inch strands of the 1/4 inch ribbon. My bridesmaid Alexa turned out to be the bow tying champ of all time. She tied each bow, varying lengths, and cut the ends on a slight angle.


HANDY TIP!!! It is way easier to make a pile of bows and cut a bunch of ribbon to start and then go through and glue it all. The process goes way faster/smoother!


Using the hot glue gun, I took a length of thin ribbon, and glued the ends.


I then put a small spot of hot glue on the back of a bow and applied it to a loop. I tried to spread the ribbon so that the bow was glued to both the front and back of the loop not just the front for more stability.


Apply a small line of hot glue to the top of a pine cone and gently press in the tail end of your loop that you hot glued into it.


Let set and you have a super cute pine cone! If you’re feeling fancy, or have a little too much ribbon showing under the bow, add a jingle bell or two!



Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s